Satel INTEGRA Plus Manuel d'utilisateur télécharger pdf (Page 7)

SATEL INTEGRA Plus 5

4. Authorization of users

Operation of the alarm system is possible after the user authorization, which allows the

control panel to verify that the user is authorized to perform the given operation. The

authorization can be done on the basis of:

 code,

 proximity card (125 kHz passive transponder, which can be in the form of card, tag, etc.),

 DALLAS iButton (chip),

 keyfob.

You can not assign the same identifier (code, proximity card, DALLAS iButton or

keyfob) to two users.

For safety reasons, different people should not use the same identifier.

The installer can configure the panel so that it will not accept codes that contain less

than three digits (e.g. 1111 or 1212) or consist of consecutive digits (3456).

The installer may permit the use of certain functions without the need for user

authorization.

Using an invalid code, proximity card or DALLAS iButton three times may:

 trigger an alarm;

 block the keypad / reader for 90 seconds.

4.1 Authorization with two identifiers

The INT-KLCDR keypads and the INT-SCR multifunction keypads have a built-in proximity

card reader. The installer can configure these devices so that the user has to use two

identifiers for authorization: the code and the card. The function to be executed after the

authorization depends on the second identifier:

– code – whether it will be confirmed by using the

key or the

key

;

– card – whether it will be presented only or held.

4.2 Factory default codes

By default, the following codes are preprogrammed in the control panel:

service code: 12345

object 1 master user (administrator) code: 1111

The factory default codes make it possible to assign individual codes to consecutive persons

who are to use the alarm system (see: section U

SERS p. 24).

The factory default codes should be changed as soon as possible using the CHANGE

OWN CODE function available in the user menu.

The control panel can inform the user that the code change is necessary, if the code is

known to other users.

The master code should not be used on a daily basis because of the risk of its being

captured. It is recommended that the administrator enter for himself an ordinary user's

code.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Satel INTEGRA Plus Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Satel INTEGRA Plus