Satel CA-10 Manuel d'utilisateur

Alarm Control PanelCA-10GDASKca10u_e 08/07USERMANUALhttp://www.ealarm.com.my

USER MANUAL CA-108arming is not affected by any detectors being violated at the time. The installer can alsoinstall a special key for quick arming of

CA-10 SATEL9tone followed by a 4-second pause - this signal corresponds to the telephoneringing tone) hang up and call again (within 5 minutes) - the

USER MANUAL CA-1010Changing display mode of system state  keyPressing and holding down the  key for about 3 seconds will temporarily change theopera

CA-10 SATEL11In the LED keypad, the [TROUBLE] and [ARMED] will go on, the [ALARM] LEDwill start blinking, while information on the last alarm will be

USER MANUAL CA-101210 - problem with transmission to monitoring station11 - not used12 - output 4 troubleThe previously detected troubles are displ

CA-10 SATEL139 - telephone line loss - the message indicates that the telephone line is cut off. Itmay also indicate lifting the receiver of a telepho

USER MANUAL CA-1014Panic alarm [#]This function activates the panic alarm from the keypad.The functions of keypad alarms may be disabled by the instal

CA-10 SATEL15User access code change [CODE][*][1]This function enables changing the access code of the user by whom it was activated.Having called the

USER MANUAL CA-1016The text mode is signaled by * in the upper right corner of the display.Numeric keys in text mode insert letters at the cursor posi

CA-10 SATEL17confirmation, if the selected user is to be deleted. If not, press the [*] key, if yes, pressthe [#] key. The numbers of users from 10 to

WARNINGIn order to avoid any operational problems with the control panel, it is recommendedthat you become familiar with this manual before you start

USER MANUAL CA-1018Silent arming [CODE][*][5]In the silent armed mode the alarms are only signaled in keypads and reported to themonitoring station. T

CA-10 SATEL19After calling the function, the control panel generates two short beeps and waits for theoutput number key (1-6) to be pressed. The contr

 - hold downfor 3 sec. to GOTOselected partition - hold down for 3 sec. to activate alarmlog viewing - hold down for 3 sec. toactivate/deactivat

 - hold down for 3 sec.to GO TO selected partition pressing the key for 3 secondsactivates Trouble Log Review - hold down for 3 sec. toactivate

CONTENTSTechnical Reliability of the Alarm System...2Alarm System Operating Costs

Technical Reliability of the Alarm SystemThe alarm system is built of the devices whose reliability is vital in effectiveness ofoffered protection. Th

CA-10 SATEL3 answering phone calls and informing the user of the system status (whether therewas an alarm condition since last arming), MONITORING

USER MANUAL CA-104Operating InstructionsOperating of the alarm system consists basically in arming and disarming the systemand responding appropriatel

CA-10 SATEL5LED FunctionsALARM (red color) – blinking LED indicates alarm in partition. The LED goes outafter alarm reset (when none of LEDs is blinki

USER MANUAL CA-106States of control panel armed zones in LCD keypadThe LCD keypad can indicate in the bottom line of its display, either periodically

CA-10 SATEL7In some keypads, the numeric keys are provided with letters. They may help the usermemorize a code by associating it with a particular wor