Satel INTEGRA Plus Spécifications télécharger pdf (Page 5)

SATEL ETHM-1 Plus 3

3 Electronics Board

Fig. 1. Module electronics board.

terminals:

+12V - +12 V DC power input.

COM - common ground.

TMP - tamper input (NC) – if not used, it should be shorted to common ground.

A RS485 B - terminals provided for future applications (RS-485).

DTM - data (communication bus).

CKM - clock (communication bus).

RS-232 port.

PWR/LOG LED:

OK – power OK,

blinking – control panel being programmed or operated by means of the module.

BUS LED – blinking LED indicates that data exchange with the control panel is in

progress.

pins for setting the module address (see "Setting address").

RJ-45 connector for Ethernet network. It is provided with two LEDs:

green – indicates connection to the network and data transmission,

yellow – indicates negotiated transmission rate (ON: 100 Mb; OFF: 10 Mb).

4 Setting address

To set an address, you must place jumpers across the ADDRESS pins. Table 1 shows how

to use jumpers in order to set a specific address (

- jumper on; - jumper off).

1 2 3 4 5 6 7 8 9 10 ... 26 27

Pas de commentaire

Satel INTEGRA Plus Spécifications Page 5