Satel INTEGRA Plus Spécifications télécharger pdf (Page 72)

70 Programming SATEL

 transmission format required by the monitoring station;

 identifiers assigned to the alarm system;

 list of event codes (not applicable to Contact ID and SIA formats).

9.1 Reporting parameters and options

See also section T

ELEPHONE OPTIONS

p. 56.

Shown in square brackets are the names used in keypads.

No module restart reports [No rest. mon.] – when this option is enabled and the Contact ID

or SIA format is used for reporting, no event codes referring to module restarts will be sent

to the monitoring station.

9.1.1 Selection of the monitoring station

Station 1 or Station 2 – the control panel will make an attempt to send the event code to

station 1 and, if unsuccessful, to station 2.

Station 1 only – the event codes are only sent to station 1.

Station 2 only – the event codes are only sent to station 2.

Station 1 and 2 – the event codes are sent to both stations. For most formats, it is possible

then to define which events will be sent to the given station (see: E

VENTS ASSIGNMENT

9.1.2 Advanced options

Long kiss-off signal – with this option enabled, the control panel will accept a long kiss-off

(acknowledgment) signal for receiving events in case of Ademco Express and Contact ID

formats. Enable this option in the event of telephone reporting if the monitoring station

acknowledges receiving events in a non-standard way (the kiss-off signal is longer than

800 ms).

Longer waiting for initial handshake – with this option enabled, the control panel will wait

longer for handshake from the monitoring station in case of sending events in the Ademco

Express, Contact ID or SIA format. Enable this option in the event of telephone reporting, if

the monitoring station sends a non-standard initial handshake.

Identifier confirmation required – the option refers to the SIA format. If it is enabled, the

control panel waits for acknowledgement by the monitoring station of receiving the

identifier with which the data were sent. The option refers to the telephone reporting.

6-character identifier – the option refers to the SIA format. If it is enabled, events will be

sent with a 6-character identifier. It consists of 2 parts: 2-character prefix and 4-character

identifier.

Send event source name – the option refers to the SIA format. If it is enabled, the name of

event source (zone, user, etc.) will also be sent along with the event code.

Send event partition name – the option refers to the SIA format. If it is enabled, the name of

partition where the event occurred will also be sent along with the event code.

Each data block conf. required – the option refers to the SIA format. If it is enabled, the

control panel waits for acknowledgement by the monitoring station of receiving each data

block. The option refers to the telephone reporting.

9.1.3 Monitoring station 1 / Monitoring station 2

Telephone number [Tel. 1 number] – basic telephone number of the monitoring station.

Backup telephone number [Tel. 2 number] – a backup telephone number of the monitoring

station. The control panel will make an attempt of reporting to that telephone number, if the

attempt of reporting to the basic telephone number fails.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 81 82

Commentaires sur ces manuels

Pas de commentaire

Satel INTEGRA Plus Spécifications Page 72

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Satel INTEGRA Plus