Satel INTEGRA Plus Spécifications télécharger pdf (Page 75)

SATEL INTEGRA Plus 73

9.1.7 Test transmissions

The test transmission may be sent:

 at a specified time. The test transmission code will be sent regularly at a defined time. The

number of days between transmissions and the time of sending transmission are

programmed.

 in specified time intervals. The test transmission code will be sent after expiry of a defined

time after the last transmission (irrespective of whether it was a test transmission or a code

of another event was sent). For each monitoring station, the number of days, hours and

minutes between transmission can be individually programmed.

9.2 Starting the reporting

9.2.1 Telephone reporting

1. Enable the R

EPORTING

–

TELEPHONE option.

2. Using the telephone options (see: section T

ELEPHONE OPTIONS

p. 56):

– determine how the telephone numbers should be dialed (T

ONE DIALING

option and – in

case of the pulse dialing – P

ULSE DIALING

1/1,5

(

OFF

:1/2)

option);

– determine whether the control panel, prior to dialing the number, should check the

telephone line for dialing signal (N

O DIAL TONE TEST

option).

3. Determine whether the event codes will be sent to both monitoring stations or to one of

them only (S

TATION

/ S

TATION

1 / S

TATION

2 / S

TATION

AND

2).

4. Program the following for the monitoring station to which event codes are to be sent:

– telephone number,

– reporting format in which the codes will be sent,

– the number of attempts to connect to the station after which, if there is no connection,

the control panel will suspend reporting (R

EPETITIONS

– time for which reporting will be suspended after the programmed number of attempts to

establish connection with the station has been made (S

USPEND TIME

– identifiers with which the events will be sent,

– events assignment (if S

TATION

AND

is selected);

– advanced options (if Ademco Express, Contact ID, SIA or TELIM format is selected).

5. If a reporting format other than C

ONTACT

(

FULL

) or SIA

(

FULL

) is selected:

– assign identifiers to the partitions, zones, keypads and expansion modules;

– program the codes for events which are to be reported.

6. Define the parameters of test transmissions.

9.2.2 Reporting via Ethernet network

The ETHM-1 module must be connected to the control panel.

Events in TELIM format cannot be sent through Ethernet network.

1. Enable the R

EPORTING

ETHM-1

option.

2. Determine whether the event codes will be sent to both monitoring stations or to one of

them only (S

TATION

/ S

TATION

1 / S

TATION

2 / S

TATION

AND

2).

3. Program the following for the monitoring station to which event codes are to be sent:

– reporting format in which the codes will be sent,

– server address,

– port number,

– IP format in which the codes will be sent (SATEL or SIA-IP),

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 81 82

Commentaires sur ces manuels

Pas de commentaire

Satel INTEGRA Plus Spécifications Page 75

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Satel INTEGRA Plus